🔋Battery Location
Jaguar S-Type Battery Location
Find where the battery is located on your Jaguar S-Type. Covers all model years with jump start points and replacement tips.
Quick Answer
The Jaguar S-Type battery is located in the engine bay on most models. Some years may have the battery in the trunk or under the rear seat — see the year-by-year breakdown below.
2003-2008
2003-2008Battery LocationEngine bay
Battery Group SizeGroup 35, 24F, or 48 (varies by engine)
CCA (Cold Cranking Amps)500 - 700 CCA recommended
Battery TypeStandard flooded or AGM
Notes
- →Disconnect the negative terminal first when removing, reconnect it last when installing
- →Clean battery terminals with a wire brush and apply dielectric grease to prevent corrosion
1999-2002
1999-2002Battery LocationEngine bay
Battery Group SizeGroup 35, 24F, or 48 (varies by engine)
CCA (Cold Cranking Amps)500 - 700 CCA recommended
Battery TypeStandard flooded or AGM
Notes
- →Disconnect the negative terminal first when removing, reconnect it last when installing
- →Clean battery terminals with a wire brush and apply dielectric grease to prevent corrosion
Frequently Asked Questions
- Where is the battery on a Jaguar S-Type?
- On most Jaguar S-Type models, the battery is in the engine bay. Some European-influenced designs and certain model years place it in the trunk or under the rear seat for better weight distribution. Check your specific year below.
- What size battery does a Jaguar S-Type need?
- The Jaguar S-Type typically uses a Group 35, 24F, or 48 battery depending on the engine and model year. CCA requirements range from 500-700. Vehicles with start-stop systems require an AGM battery.
- How long does a Jaguar S-Type battery last?
- A Jaguar S-Type battery typically lasts 3-5 years. In hot climates like Texas and the Southwest, expect closer to 3 years. AGM batteries in start-stop equipped models may last 4-6 years.
- Can I replace the Jaguar S-Type battery myself?
- Yes, battery replacement is a straightforward DIY job on most Jaguar S-Type models. You'll need a 10mm wrench for the terminals and possibly a 12mm or 13mm for the hold-down bracket. Some newer models may need a battery registration scan with an OBD2 tool.